Step 1 – Make sure the Power Supply is connected well and that there is power in the wall outlet. If Yes – Proceed to Step 2. If No –...
RS Model FAQs
Start Inside Message
Step 1 – Basically, the mower “thinks” it isn’t inside the installed wire area. This indicates something is wrong with the wire, the base station, power supply or mower front...
Unresponsive buttons on LCD panel
If you experience unresponsive buttons on your Robomow mower’s LCD panel, please follow the steps as outlined below: Test the buttons operation through Mower’s Service Menu ⇢ 897 ⇢ Tests...
Short Run Time (RS Models)
From docking, when sending mower to edge, or to mow a sub zone, mower starts mowing in main zone. May mow for a very short period: 10ft-50ft (3-15m)) then stop...
Slippage Message
Issue: The mower has odometer (magnet and sensor) in the front wheel and odometers in the drive motors, and both odometers are compared to one another constantly. A simple case...
Rain Sensor is not working
This message will display after the mower had attempted docking a few times unsuccessfully. Step 1 – Go to Service ⇢ 897 ⇢ Information ⇢ Special Display ⇢ Rain Sensor...
Software Resets – Types and when to use
Software Reset When mower behaves oddly (i.e., will not go to a zone you just set, out of the base station, will not show the icon for going home), be...
Sent to Edge or a Zone but Goes to Mow – Strange behavior
Problem: From base station, when sending mower to edge, or to mow a sub zone, your mower begins mowing in main zone instead. It may mow for a short period...
Bumper Pressed Message
Issue: Mower stopped or found stopped with this message on display. Step 1 – Check whether bumper is mounted and locked well on its four joysticks on the frame. If...
Base Problem Message
This message will display after the mower had attempted docking a few times unsuccessfully. Step 1 – Experience shows this could be a case where bumper calibration is needed. Look...