Robomow not going to sub zone when setting up

Step 1 – Experience shows this could be a case where bumper calibration is needed.

  1. Take the mower out of the base station and perform Bumper Calibration through Service ⇢ 897 code ⇢ Calibrations ⇢ Bumper.
  2. Place the mower in the base station and send it to mow.

Did it fix the issue?

If Yes – Problem solved.

If No – Proceed to Step 2.

Step 2 – In this case we need to diagnose the mower perimeter wire related hardware. See the article No Wire Signal Message.