Step 1 – Is “Demo Mode” set On? If Yes – Go to Service Menu ⇢ Settings ⇢ Software Version ⇢ Demo (Screen 253) ⇢ On/Off. Switch it Off and...
RS Model FAQs
Bumper Events
Issue: Mower stopping and changing direction as if bumped into an obstacle, when there is no obstacle there. Perform a Bumper calibration through Service ⇢ 897 ⇢ Calibrations ⇢ Bumper....
Drive Overheat, Overcurrent, Disconnected or Start Elsewhere Message
These messages can be displayed on the base station while warming up or during any operation, automatic or manual. “Start Elsewhere” Message Drive wheel motors have been working under a...
Driving in Curved Lines or Circles
Step 1 – Inspect both drive wheels to see if sticks, toys, accumulated mud, or mulch is slowing down one of the wheel’s rotation. Clean well and send the mower...
Maximum Wire Length for RS Models
When installing the perimeter wire, please be sure to follow the written instructions in the Operating and Safety Manual. Also, check to ensure that the installed perimeter wire length and...
No Wire Signal Message
Step 1 – Is there any light on the base Station Head? If Yes – Proceed to Step 2 If No – See the article Base Station Head Does Not...
Check Mow Height / Mow Overheat Messages
Step 1 – Is it the first cut of the season or is the grass very high? If Yes – Raise mowing height level to the highest level and let...
Noises Heard from Various Places of the Mower
Step 1 – Turn the Safety/Main Switch to OFF, lift the front of the mower and check for any visible reasons creating noise with regards to the mowing system. Possible...
Erratic Behavior
Step 1 – Mower stops or changes direction where there is no obstacle or wire, or may be missing specific areas. Is there a high current electricity cable or metal...
GSM Issues
Step 1 – If you suspect a GSM is not working, please take the steps as outlined below. Note: This procedure is not available for now due to the removal...